Drawings and documents
National Archives restored drawings: drawing
D.H. Bond's Patent Drawing for a the Manufacture of Over Shoes
National Archives, Restored Patent Drawings (Record Group 241) · Full-size scan at the National Archives · Catalog record
Show the text on the drawing Hide (56 words)
Words on the drawing as machine-read by the National Archives; not checked. Useful mainly for searching.
BOOTS & shoes.) / [16] Uppers. / 300 ASSUTICATION / 9803. + / DIVISION / Patented 30 magun / 9803 X Round toed Shoe made use / June 30 18 / intracement sline / Square toell Sline madeline / Cut of Lenther / Patent office / Madeunder the direction of the com / hatents in conformity with actz 3"ll / Mount
USPTO scan
The patent as scanned by the USPTO
U.S. Patent and Trademark Office · Google Patents
Show the transcription Hide (596 words)
Machine transcription (LightOnOCR) of the pages as scanned by the USPTO, most of them the handwritten copies made when the records were restored after the 1836 fire. Not checked; it can misread handwriting, so compare it with the scan.
Page 1.
9803X
D. H. Bond,
Shoe Upper.
Patented June 30, 1836.
Round toed Shoe made up.

Cut of Leather for round toed shoe.
Square toed Shoe made up.

Cut of Leather for square toed shoe.
M. PETERS, PHOTO-LITHOGRAPHER, WASHINGTON, D. C.
Page 2.
June 30, 1836 117.
Daniel H. Bond of Canterbury, Connecticut
Letters Patent 9803X
(507)
The Schedule referred to in these Letters Patent, and
making part of the same, containing a description in the
words of the said Daniel H. Bond himself, of his Improvements in the manufacture of Ladies and Gentlemen’s Leather over-shoes.
To all to whom these presents shall come.
We it is known that I, Daniel H. Bond of Canterbury, in the County of Windham and State of Connecticut have invented a new and useful improvement in the making, or manufacturing, of Ladies and Gentlemen’s over-shoes of leather which invention is as follows:
The leather should be dyed in the same manner as harness or little leather and from ½ to ⅞ of an inch in thickness. The shoe contains but one piece of leather, the upper and sole joining between the heel and the ball, there is a seam joining the sole and the upper from the ball to the center of the toe if round, or if the toe is to be made square, the sole is cut about one inch longer than the last, made pointed and turned over the end of the last, so that three seams connecting the sole and the upper will be on at the corners of the toe and meet in a point on the top of the shoe about one inch from each corner, from this point a seam extends about two inches towards the instep on the top of the shoe, at the termination of this seam the leather laps about one inch and is stitched or bound twice across. From this stitching, or lacing the upper is left open to the toe, the leather as before observed lapping over the instep about one inch and is secured
Page 3.
118.
with a strap and buckle — the quarters at the heel are closed up, similar to the quarters of a common shoe, there is a short seam joining the sole to the quarters around the back part of the heel. The shoe is closed on the wrong side and turned which is scarcely done dipping it in warm water, it is then last ed while wet and dried on the last a heel may be put to it with pegs or nails. When the shoe is perfectly dry, the last is taken out, and an inner sole or lining cemented to the bottom on the inside, the shoe may then be made water proof, by Indian Rubber prepared in the following way. Take one gallon of the oil of tar, and put into it about 6 ounces of Indian Rubber cut into small pieces, set it in a warm place and stir it occasionally until the Rubber is dissolved; give the shoe two or three good coats of this both inside and out and it is perfectly impervious to water. Common rosin softened with the above preparation makes a very good cement for the inner sole or lining.
In witness whereof I hereunto subscribe my name the 27th April 1836.
Witnesses
Joseph E. Simnick
David W. Adams.
(510 words)
Published accounts: journal notice
Notice in the monthly list of patents (listed with a different spelling or date)
Journal of the Franklin Institute, new ser., vol. 18 (1836), p. 287 · View the page
Over shoes. Daniel H. Bond, Canterbury, Conn.
About this record
- Patentee
- Jim Shaw's X-patent list
- Date
- the Name and Date index of patents, USPTO records, Jim Shaw's X-patent list
- Invention
- the Name and Date index of patents
- Listed in
- the Name and Date index of patents, USPTO records, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Journal, Burke's List of Patents (1847)
- Also listed in a contemporary journal or list under a different spelling or date; the record shown follows the standard lists.
- Burke's 1847 Patent Office list gives the same patent.