Drawings and documents
National Archives restored drawings: drawing
Daniel Sheldon's Patent Drawing for a Churn
National Archives, Restored Patent Drawings (Record Group 241) · Full-size scan at the National Archives · Catalog record
Show the text on the drawing Hide (393 words)
Words on the drawing as machine-read by the National Archives; not checked. Useful mainly for searching.
31 DATRY. / 31, / Churns. Reciproc. Churus / 45] / Reciprooating Thurns. / 6252 / Agr.pm Ducts / 4878. + / Denil Station's / s 3 / Patented: 13 Sept. 1827 / to / 08 / II / Re ferences / to A handle, 1% inch diameter, 2 feet in length, which it mortised / A. The body of the churn and ears or two staves, which extend / at the end and placed on the outside of the wheel and made fast, / about 15 -inches above the churn, in one of which is a martise / which can be moved up and down with the hand and turns the buckets / for a wheel, and a cap piece placed on the top -- the body of / the churn 2 feet high, , foot at bottom. / H A pitman which goes into the handle and into a stick made fast to / entirely round either way. / B. A wheel about 9 inches in diameter, / inch thick, placed in the / the rockers. / mor tise in the ear of the charr. / a A stick with a montine in the and to receive the pitman and made / c. / A strap which is attached to the apper and under side of / the wheel, linch in width with a buckle in the same fastened / H. A chair in which a person can sit and by rocking charn in few minutes. / fast to the rockers. / near the handle on the edge of the which on both sides from thence / I. A side view of one of the buckets which stand in the charn about / both straps pafses once round the shaft of the first bus ket, / 1/4 inch apart from the outside of the siato and widest at the bottom / thence round once or twice the other shaft and made fastal / J. / A frame of four pieces into which can be placed a common charn / the end The be ckcles are for the purpose of making the straps / or any wooden refull for the purpose of churning cream with the what / tight or taking apart. / straps buckets, sc agreeable.the above drawings. / D. The two shafts 1 1/4 inch diameter, which extend into the / A. Rockers on which is placed a board, on that a chair Holes are / churn from cap-piece, on which are 4 buckets each or slats, / 2 inited wide, 1/2 inh thick, about 9 inches in length. / to be made in of board to receive the past of the same
USPTO scan
The patent as scanned by the USPTO
U.S. Patent and Trademark Office · Google Patents
Show the transcription Hide (508 words)
Machine transcription (LightOnOCR) of the pages as scanned by the USPTO, most of them the handwritten copies made when the records were restored after the 1836 fire. Not checked; it can misread handwriting, so compare it with the scan.
Page 2.
United States Patent
Patent No.: X4878
Daniel Sheldon
Letters Patent (Patented September 13, 1827)
The schedule reference to in these Letters Patent, & making part of the same, containing a description in the words of the said Daniel Sheldon, himself of his improvement in the churn.
The buckets running in a horizontal position in the churn, first turning around those, with the shafts that run through the center of these buckets running a sufficient height so as to attach the cords & cog wheels to propel the same by a large wheel or wheel with cogs or straps as the case may require. — This large wheel is made in proportion to the size of the churn, the platform of pine plank one inch & a quarter thick, & fifteen inches wide; two posts framed into this platform of one inch and a quarter thick, & fifteen inches wide, two posts framed into this platform, of one inch and a quarter thick, & four inches wide, the length agreeable to the height of the churn, a cross piece running immediately above the lid of the churn & mortised into the two upright posts, of one inch thick, & four inches wide, framed in two pieces so as to take it apart that the buckets can be taken out or put in at pleasure — A top piece of one inch thick, one three inches wide, on the top of one of the upright shafts, a mortice of sufficient width to receive the big wheel, a handle running from the center of the big wheel — this handle to be from two and a half feet to three feet long, agreeable to the height of the churn, a pitman attached to the handle of sufficient length so as to be attached to two rockers purposely fixed to propel the machinery and a chair placed on these rockers so that a woman can sit & nurse her child, & churn at the same time; or be propelled by the hand without a pitman, if you make a new churn, this frame can be dispensed with instead of the two upright posts, save the staves of the churn to be left above the
Page 3.
United States Patent
Patent No.: X4878
chosen sufficient height to embrace the machinery, & the machinery placed in the same manner as heretofore mentioned in this schedule. These brackets heretofore mentioned, to be made of slats running in a line with the shafts so as to mesh regularly through each other, those slats to be 3/4 of an inch thick & 2 inches wide, & the first description of those brackets reference being made to the drawings of the machine.
Witnesses
Joseph Heathaway
C. M. Wright
(240 words)
621. 1196.
Daniel Sheldon
(457 - 4)
Page 4.
United States Patent
Patent No.: X4878
D. Sheldon.
Churn
Patented Sept. 13, 1887.

Published accounts: journal notice
Notice in the monthly list of patents
Journal of the Franklin Institute, vol. 5 (1828), p. 211 · View the page
In the churn; Daniel Sheldon, of Pultney, Steuben County, New York, September 13.
About this record
- Patentee
- Jim Shaw's X-patent list
- Date
- the Name and Date index of patents, USPTO records, Jim Shaw's X-patent list
- Invention
- the Name and Date index of patents
- Listed in
- the Name and Date index of patents, USPTO records, Jim Shaw's X-patent list, the Journal of the Franklin Institute, the Mirror of the Patent Office (1828), S. A. Elliot's printed list of patents
- The Franklin Institute's journal spells the name differently.
- The residence comes from the Franklin Institute's journal.
- The Mirror of the Patent Office's supplementary list gives the same patent.
- S. A. Elliot's printed list of patents gives the same name and date.