Drawings and documents
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 3 (1829), p. 57 · View the page
33. An improvement in the Plough; Stephen M'Cormick, Fauquier county, Virginia, October 22.
Remarks. The original patent for this improvement, was issued January 28, 1826; but in consequence of defects in the specification, this has been surrendered, cancelled, and the seal broken, and the present patent issued, bearing date with the former. The specification of the above invention is of considerable length, and the subject not to be understood without the drawings, which, at present, it is not our intention to furnish. There are models in the patent office of about 120 varieties of the plough, varieties, we say, VOL. III.-No. 1.-JANUARY, 1829. 8 although in many instances it would be difficult to tell in what the difference between them consists. Mr. M.Cormick's is said to be * a good plough, and the improvements which he claims, are, "First. The share, &c.; the bar made thick at the bottom, and thin on the top edge; putting a piece from the point of the share of the plough, up to the point of the mould board; and the application of the improvement in the shoe, to raise and lower behind, at pleasure. "Second. The method in which the mould board is wrought; the shape of its face, or mould part; the curve, or projection over towards the land side; the long hole through its top, for the beam bolt; the catch at the bottom to fasten it to the share; and the concave groove bove for the handle. "Third. The situation of the fore part of the mould board for the cast share, and the self-sharpening point; the position of the brace bar, between the land side and mould board, for the point to rest on, and to fasten it to; the length of the point, and the manner in which it is fastened to the brace bar; the shape of the share, for the point to rest upon. "Fourth. The shape of the sword with two edges; the manner in which it is fastened to the side of the beam with a staple. "Fifth. The stock; the method of fastening the handle and beam together, with a staple; fitting the handle in the concave groove; and adjusting the beam on the top of the mould board: all of which is fully specified in the foregoing."
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, the Journal of the Franklin Institute