Drawings and documents
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 4 (1829), p. 125 ยท View the page
12. For improvements in the art of Sawing Boards and other kinds of Lumber, and in the construction of saw mills, crank wheels, and gearing; Israel Johnson, jun., Moriah, Essex county, New York, May 7.
Remarks. 1st. The saw frame is to be made lighter than usual, say of 3 by 4 scantling; it is to be framed together by four cross pieces instead of two, the pair at top, and at bottom, to be each about two feet apart, with braces of wood or iron to stiffen them. 2nd. The pitman is also to be made light, with a brace from each side extending up to the bottom rail of the saw frame; this rail consequently working on three joints, or noddle pins. 3d. The crank wheel is to be balanced, that is, a weight is to be put upon the shaft upon the side opposite to the crank. A very great advantage is anticipated from so doing; as the patentee supposes that much power is lost by having to lift the weight of the crank on one side. 4th. Spring poles are to be made to operate upon the pitman. These are greatly to relieve the crank, not only in its labour of passing the dead points, but to co-operate with the power, both in raising and depressing the saw gate, or frame. 5th. A veneer saw wedge is to be fixed upon a thin saw plate. This wedge is a strip of iron the length of the saw, and is to be fixed upon that side of it next to the veneer. It is made wedge-shaped, its edge being placed towards the teeth, and its thick part towards the back of the saw. This is to give stiffness to a thin saw, and cause it to run as truly as a thick one. The wedge turns off the veneer, or other thin stuff which is being sawed. 6th. A horizontal circular saw running upon a vertical axis is proposed to be used. The description of this is not very clear; but it seems to be intended to cut veneers, &c. from the upper surface of a log placed upon a carriage, or from two logs at once, it being placed between them. A circular veneer saw wedge may be used to give it stiffness. 7th. Instead of cog wheels, friction wheels, or rather faced wheels, without teeth, turning each other by their friction, are proposed to be used for saw mills, and other heavy gearing.
About this record
- Patentee
- Jim Shaw's X-patent list
- Date
- the Name and Date index of patents, Jim Shaw's X-patent list
- Invention
- the Name and Date index of patents
- Listed in
- the Name and Date index of patents, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- The Franklin Institute's journal spells the name differently.
- Burke's 1847 Patent Office list gives the same patent.