Drawings and documents
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 6 · View the page
13. For a tool called a Screw Swedge, for Cutting or Forming the Screw Thread in Brass, Iron, Steel, or other Metal; Richard Whitney, Baltimore, Maryland, April 10.
Remarks. This patent is taken for the forming of screws on "common screwbolts, wood screws, and all other purposes for which it is necessary that the screw thread be cut thereon; and an easy method of forg⚫ing the nuts to be used with said screws after they are thus formed, or made in the old way, with a plate; the aforesaid tool answering all the purposes of common screw plates now in use." The tools for which this patent is taken are very clearly described, and distinctly represented. There must be a pair of swedges made, one of which may fit into the eye of the anvil, as usual; the upper swedge should have a proper handle and a guide to insure its standing correctly over the lower. In each of these swedges one-half the intended screw is to be sunk just as they are in the dies in screw stocks. The heated metal is to be placed between these, and the screw formed in them by forging. The thread may be angular, or square, as may be desired. For some purposes this contrivance will undoubtedly answer, but it must be for very common purposes. The stretching, or lengthening of the screw, produced by the common stocks, and especially by the screw plate, which is so injurious to those screws which are intended to work in deep nuts, will be produced in a much greater degree by the proposed plan, excepting in those instances where the length of the screw is not greater than that in the die. To talk of forging screws of brass in such tools may do for one who has never essayed the working in that metal; we are assured that no worker of brass will violate this part of the patent. We know that screws might be so cut upon small, cold, brass wire, but we also know that it would be very far from an improvement. The method prescribed for forging the nuts, is to make them in the usual way, punching the hole sufficiently large to pass over the tap, then to heat them, and forge them on the tap, by striking carefully on their square edges, so as to bring up the thread. Such nuts, if they are to be neatly finished, will require more labour in filing their sides than would have been necessary to cut a good screw with a tap.
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- Burke's 1847 Patent Office list gives the same patent.