Drawings and documents
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 301 · View the page
3. For an improvement in the Manufacturing of Paper by means of a machine called a "Pulp Dresser;" Elihu H. Thomas and Nathan Woodcock, Brattleborough, Windham county, Vermont, August 11.
Remarks. (See the specification.)
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 307 · View the page
Be it known that we, the said Lewis Wooster and Joseph E. Holmes, have invented, constructed, made and applied to use, a new and useful improvement in making or manufacturing paper for writing, printing, wrapping, and boards, from wood; the preparation of which, for making the paper in the common paper mill, is as follows, viz. The wood is reduced to shavings of the ordinary jack-plane shaving size, or bruised so as to be rendered of nearly the same size of the shaving; they are then placed in a cistern, or boiler, of sufficient dimensions, and covered with water, which is put to a boiling heat. To every one hundred pounds of the wood (thus reduced) put from twelve to eighteen pounds of alkali, either vegetable or mineral, in proportion to its quality for strength. If salts are used, THOMAS and WOODCOCK'S Pulp Dresser. they should be reduced before they are placed on the wood in the cistern, or boiler, with the water; they may, however, be put in with the water and wood before reduction, but the first mode is found the most preferable. Should lime be used, there must be a sufficient quantity in all cases to equal twelve pounds of pure black salts. For every one hundred pounds of wood, which may be leached before being placed in the cistern with the wood and water, or thrown in, in its pure state. One hundred pounds of wood, will, if well attended to, make from five to seven reams of paper. LEWIS WOOSTER. JOSEPH E. HOLMES. Specification of a patent for an improvement in the manufacture of Paper, by means of a machine called a “Pulp Dresser." Granted to ELIHU H. THOMAS and NATHAN WOODCOCK, Brattleborough, Windham county, Vermont, August 11, 1830.
Remarks. THIS improvement consists of a box about two feet square and one foot deep. Inside of the box, near the bottom, is placed a hog, or float wheel, or agitator, about 7 inches in diameter, and as long as will play freely inside of the box. One end of the hog shaft passes through one side of the box, and receives a pulley which is connected with some moving power, so that a rapid motion is given to the hog. Directly on one side, and nearly over the hog, is placed a sieve or screen, on an angle of about 45 degrees, with apertures so fine that knots and other offensive particles cannot pass through; but with the agitation caused by the hog, the pulp is allowed to pass freely when diluted with water. A partition of board is placed on the opposite side of the hog, much like the screen; the tops of the screen and partition are united together when in use, in such a manner as the pulp shall not get through between them. The partition reaches within about two inches of the bottom of the box; the pulp flows in at one end of the box, and passes under the partition, is then washed through the sieve or screen, and flows out at the opposite end of the box through an aperture.
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 308 · View the page
The sieve, or screen, is made of triangular bars of metal, about one-fourth of an inch in width on each angle; these bars are made straight and true, and placed near enough to each other to prevent coarse particles passing through the apertures. These bars may be made circular, and placed perpendicularly or horizontally, with a revolving or vibrating hog, which we conceive to be our principle. We do not claim as our invention, the hog, or agitator, for mixing and giving motion to pulp in the manufacture of paper, nor of the common engine for grinding rags into pulp. But we claim the discovery of applying the hog and common engine to the purpose of forcing the pulp through the apertures of a screen or sieve, for the purpose of separating knots and filth from the pulp. ELIHU H. THOMAS. NATHAN WOODCOCK. Specification of a patent for an improvement in the art of Cutting and Casting Music Type. Granted to GEORGE B. LOTHIAN, City of New York, August 11, 1830.
Remarks. The staff lines are fitted on single bodies, and dress up to the face on the extreme edge of the body, leaving no shoulder. What I claim as new, and my own invention and discovery in the above described type, and for the use of which I ask an exclusive privilege, is: In cutting and casting but one staff line on #623468 the time marks, they are, therefore, as readily made to line as a plain staff line. The type thus cast projects nearly one-half over the body, and fits on to the plain staff lines, above and below. In cutting and casting the angular quavers without any projection over the body, and a line, thus -, or an angle thus, or thus, is cast on a body equal to an entire quadrate, or half the size of the body of the staff lines, which is placed in the composing stick first, and then the quaver on it, which causes the quaver to run on the next line below, thus. An en quadrate or character on the half body is placed next in the composing stick, and makes up the two lines.
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- Burke's 1847 Patent Office list gives the same patent.