Drawings and documents
Published accounts: specification
Specification printed in the Journal of the Franklin Institute
Journal of the Franklin Institute, new ser., vol. 6 (1830), p. 383 ยท View the page
Text of the specification as printed in the Journal, from OCR; not proofread.
Specification of a patent for a Perennial Fountain Pen. Granted to MARCUS T. C. GOULD, Stenographer, of the City of Philadelphia, October 1, 1830. Be it known, that I, Marcus T. C. Gould, of the city and county of Philadelphia, and state of Pennsylvania, have made a new and useful improvement in a pen for writing with ink, called the Perennial, or Self-supplying Fountain Pen; and that the following is a full and exact description of its parts, construction and use, viz. 1st. A cylindrical barrel, of gold, silver, glass, or other material, about five inches in length, and one-third of an inch in diameter, to be filled with ink. 2nd. A shaft of metal or other substance, screwed into the lower end of the barrel, and projecting downward, below it, about half an inch, and forming in its diminished size, a collet, upon which is slid a common, or metallic pen. 3d. A small tube, or conductor, of gold, silver, or other material, passing upward through the collet, and communicating with the column of ink, by means of a regulator, hereafter described; and at the same time extending downwards, along the centre of the pen, with the lower end so bent as to open directly upon the split of the pen. 4th. A hollow wire, or rod, called the regulator, passing through the upper end of the barrel, and extending downwards through the barrel and shaft till it meets the ink tube, about midway of the shaft and collet. This regulator has a small groove, or other opening, near each end (and within the fastening or packing box, at each end of the barrel) for the purpose of admitting, when unscrewed, ink below and air above-that is, ink into the tube and air into the barrel; and at the same time opening an uninterrupted channel through the whole length of the instrument; through which, if the regulator be screwed down, and opened above, air, or water, may be forced for the purpose of cleansing the tube, and that, without communicating with the ink in the barrel. 5th. A piece of sponge, or other porous substance, attached to the wire immediately above the shaft, and filling the entire diameter of the barrel, about 4 of an inch upward, thus forming, when the regulator is unscrewed and the pen in use, a strainer of the ink, and a regulator of its flowing; or, when screwed down, and the pen at rest, a general valve upon which the whole column of ink may rest. Immediately above this spongy substance, is attached to the rod, a thin, flat circular plate, or follower, equal in width to the inner diameter of the barrel; this plate should be finely perforated in various places near its circumference. 6th. A small stopper, at the upper end of the regulator, and a suitable cap at each end of the barrel, to give a finish to the whole, completes the instrument. GOULD'S Perennial Fountain Pen. Remarks upon the construction and use. The regulator should be so adjusted as to open or close the air vent and ink valve, simultaneously; and, if preferred, the object may be effected by a pressure of the finger, or thumb, when writing, upon a spring near the lower end of the barrel, instead of turning a screw, or regulator, at the top, as above described. The ink tube should not perfectly coincide with the axis of the collet, but incline a little towards the circumference at the lower end, so that by turning the pen and conductor, (or ink tube,) a greater or less pressure may be produced between the two, at their junction. The collet should be of sufficient length to allow of sliding the pen, so as to bring the nib nearer to, or farther from, the mouth of the tube, when it shall be desirable to make the ink flow faster or slower. If these several points be attended to, the instrument will be regulated in four separate and distinct methods; and when charged, will supply itself for hours together, as fast as may be desired by the writer, whether writing slowly or rapidly; for the opening and closing of the split of the pen, when in use, will cause the ink to flow in exact proportion to the number of motions produced; and when the pen ceases to move, the ink will cease to flow. The improvements claimed are these, viz. 1st. Conducting ink from a reservoir, or fountain, directly to the split of the pen, through a tube opening upon the concave surface of the pen. 2nd. Straining the ink from impurities, and regulating its flowing by a spongy or porous substance within and at the bottom of the barrel. 3d. The method of opening and closing the ink tube and air vent. 4th. The provision for clearing the ink tube, when clogged. MARCUS T. C. GOULD. References to the drawing of the section of the pen. A, cylinder barrel. B, shaft. C, collet. D, small tube or conductor. E, regulator. F, opening to admit ink to the regulator. G, opening for air. H, stopper to the opening. I, Groove to admit air to the barrel. K, piece of sponge. L, follower. M, nib of the pen. A M H L K F B C D E
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, Burke's List of Patents (1847)
- Burke's 1847 Patent Office list gives the same patent.