Drawings and documents
Published accounts: specification
Specification printed in the Journal of the Franklin Institute
Journal of the Franklin Institute, new ser., vol. 7 (1831), p. 384 · View the page
Text of the specification as printed in the Journal, from OCR; not proofread.
Specification of a patent for a mode of constructing Flues, or Stoves, for the Curing or Drying of Tobacco. Granted to DAVID G. TUCK, Halifax Court House, Virginia, February 15, 1831. To all to whom these presents shall come:-Be it known, that I, David G. Tuck, have invented, or discovered, a new and useful improvement in the construction of flues, or stoves, for the curing or drying of tobacco, by which the whole or greater part of the smoke, as may be preferred, is excluded, and the expenses consequent upon the process very much diminished; and that the following is a full and exact description thereof. The material of which I usually construct the said flues or stoves, is common brick, as, under most circumstances, it is more readily obtained, and is less costly than any other. They, however, may be made of stone, iron, fire brick, slabs, or tiles, made and baked in the manner of brick, or of other materials. The dimensions of my said flues, or stoves, must be varied to suit the size of the barn, or drying house, in which they are to be used; and they will also admit of considerable variation in this particular in houses of any size, whilst the principle of construction may yet be retained. For the sake of description, I assume certain dimensions, which I have found to answer the intention perfectly, but do not intend to establish any limit in this particular. These stoves, or flues, are to be so constructed that they may be TUCK's Stoves, or Flues, for Curing Tobacco. supplied with fuel from the outside of the house, and that the smoke, and other vapours from the fire, which it may be desirable to exclude from the interior of the building, shall, after passing through the larger flue, or stove, in which the fire is contained, to a spot near the centre of the building, return through a second, but smaller flue, which may be parallel to, and in contact with that first named, and be delivered, or have its exit, near the opening for feeding the fire. Suppose my barn to be twenty feet square, and of the ordinary height. Near the middle of one end, or side, of the barn, I make an opening for the mouth of my flue, or stove; this flue, or stove, is a square, or arched trunk, about 30 inches in width, and the same in height. It is built horizontally upon the floor of the barn, and extends within it to the distance of about seven feet from the wall. The outer end, where the fire is to be fed, is furnished with an iron door of about a foot square. To receive the inner end of this flue, a square, or other formed pen, or box, is erected of brick, or other materials. This pen, or box, may be four feet in length, and two in width, and of the same height with the larger flue, or stove, which terminates in it. It should stand at right angles with the flue, or stove, which is to enter it on one of its broad sides. The smaller flue, through which the smoke is to return, also opens into this box, or pen, alongside of the large flue, and may return, and pass through the building, in the vicinity of the fire place, or feeding door. This second flue may be made of the same materials with the former, but need not be more than one-fourth of its size. From the end of it, a flue, or pipe, is erected perpendicularly to the height of four or five feet, to serve as a chimney to furnish a draft, and carry off the smoke. The interior diameter of this chimney need not exceed seven or eight inches; and an iron plate, or some other flat article, must be provided to stop the draught when required, by being placed upon the top of said flue. It is manifest that in a structure of this kind, a fire may be made, and that the smoke will pass out at the chimney; but as soon as the wood is charred, and the fire burns clear, it is intended to admit the heated air into the barn, and to stop the draught through the flue, or chimney. For the purpose of admitting the heated air, the pen, or box, before described, is provided with an iron, or other door, or stopper, opening from it into the barn. This door may be twenty inches square; it may be fixed by hinges, or otherwise, so that it may be opened as soon as the smoke has ceased to escape from the chimney, and at this time the top of the chimney may have its cover placed so as entirely, or partially, to stop the draught through it. A second flue, or stove, constructed exactly like the one just described, with all its appurtenances, is to be erected on the opposite side of the barn. The pens, or boxes, forming the termination of each of these flues, or stoves, will thus leave a passage of about two feet between them, on the centre of the floor. These flues, or stoves, may be used either separately or conjointly; it will be found best, however, always to make a fire in each, as VOL. VII. No. 6.-JUNE, 1831. 49 ८ HOWARD'S Bucket Water Wheel. there will then be no interval in which the heated air from the fire may not be admitted directly into the barn. The manner in which the heat may be regularly distributed, and applied to the curing of tobacco, is fully described in the specification of a patent for a new mode of curing tobacco, which was granted unto me on the 1st day of October, 1830. To the system, or mode of procedure therein described, these flues and stoves are particularly adapted, but they may also be used when tobacco is cured in the ordinary way. Where flues are carried directly through a barn, or drying house, the draft cannot be advantageously managed, and most of the heat is lost; a difficulty completely obviated by flues, or stoves, constructed upon the principle above described. What I claim as my invention, or discovery, is the application of flues, or stoves, constructed upon the within described principle, by which the heated air from the fuel may be admitted, directly, into a barn, or drying house, for the purpose of drying and curing of tobacco, whilst the smoke may be entirely excluded. I also claim the returning of the draft of the flue, or stove, to a point, at or near to the feeding door of the stove, by means of which the draft of the fire is readily and perfectly managed, so as to produce great economy in the use of the fuel. The escape flue, however, may be carried out at any part of the building, although not with equal advantage. It may, for example, be carried directly through the house, and yet the main object of my patent, that of admitting the heated air without the smoke, may still be attained. D. G. TUCK. D. G. Tuck's Stoves or Flues. B E A, the stove for fuel. B, pen, or box. C, iron door, opening into the barn. D, return flue for smoke. E, pipe, or flue, to carry it off.
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 7 (1831), p. 374 · View the page
24. For constructing Stoves, or Flues, for the Curing or Drying of Tobacco; D. G. Tuck, Halifax county, Virginia, February 15.
Remarks. (See the specification.)
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 7 (1831), p. 383 · View the page
Some additional power may be obtained by the application of a funnel to each of the holes in the ends of the arms, a, a, a, a, &c. the small end of the funnel being applied to the hole, and the wide end standing outward. These funnels may be of small blocks of wood with a hole bored through the middle of each, and hollowed on the inferior side so as to fit the arms to which they may be attached, firmly, by nails or screws. The holes in the blocks should correspond in capacity and position on the inferior sides with the holes in the arms, and should gradually widen in the true funnel shape towards the outer surface of the blocks. These funnels may, or may not, be attached, at the option of the constructor; the machine will operate very well without them, though it is believed, from experiment, with some increase of power with them. If a reciprocating motion is desired it may be obtained by means of a crank on the axle of the shaft A. In the machine above described the crank is at the end of the axle: but if the axle a little prolonged, be made to work on a point fixed in a permanent block placed directly opposite the smaller extremity of the shaft, and in the intermediate space between the end of the shaft and the block, the axle be so shaped as to form a crank, by which the reciprocating Tuck's Stoves, or Flues for Curing Tobacco. movement may be given, there will be less friction and-consequently a gain of power. H JOSEPH C. STRODE. Strode's Reaction Wheel. G F h E I A D B de Specification of a patent for a mode of constructing Flues, or Stoves, for the Curing or Drying of Tobacco. Granted to DAVID G. TUCK, Halifax Court House, Virginia, February 15, 1831.
Remarks. To all to whom these presents shall come:-Be it known, that I, David G. Tuck, have invented, or discovered, a new and useful improvement in the construction of flues, or stoves, for the curing or drying of tobacco, by which the whole or greater part of the smoke, as may be preferred, is excluded, and the expenses consequent upon the process very much diminished; and that the following is a full and exact description thereof. The material of which I usually construct the said flues or stoves, is common brick, as, under most circumstances, it is more readily obtained, and is less costly than any other. They, however, may be made of stone, iron, fire brick, slabs, or tiles, made and baked in the manner of brick, or of other materials. The dimensions of my said flues, or stoves, must be varied to suit the size of the barn, or drying house, in which they are to be used; and they will also admit of considerable variation in this particular in houses of any size, whilst the principle of construction may yet be retained. For the sake of description, I assume certain dimensions, which I have found to answer the intention perfectly, but do not intend to establish any limit in this particular. These stoves, or flues, are to be so constructed that they may be TUCK's Stoves, or Flues, for Curing Tobacco. supplied with fuel from the outside of the house, and that the smoke, and other vapours from the fire, which it may be desirable to exclude from the interior of the building, shall, after passing through the larger flue, or stove, in which the fire is contained, to a spot near the centre of the building, return through a second, but smaller flue, which may be parallel to, and in contact with that first named, and be delivered, or have its exit, near the opening for feeding the fire. Suppose my barn to be twenty feet square, and of the ordinary height. Near the middle of one end, or side, of the barn, I make an opening for the mouth of my flue, or stove; this flue, or stove, is a square, or arched trunk, about 30 inches in width, and the same in height. It is built horizontally upon the floor of the barn, and extends within it to the distance of about seven feet from the wall. The outer end, where the fire is to be fed, is furnished with an iron door of about a foot square. To receive the inner end of this flue, a square, or other formed pen, or box, is erected of brick, or other materials. This pen, or box, may be four feet in length, and two in width, and of the same height with the larger flue, or stove, which terminates in it. It should stand at right angles with the flue, or stove, which is to enter it on one of its broad sides. The smaller flue, through which the smoke is to return, also opens into this box, or pen, alongside of the large flue, and may return, and pass through the building, in the vicinity of the fire place, or feeding door. This second flue may be made of the same materials with the former, but need not be more than one-fourth of its size. From the end of it, a flue, or pipe, is erected perpendicularly to the height of four or five feet, to serve as a chimney to furnish a draft, and carry off the smoke. The interior diameter of this chimney need not exceed seven or eight inches; and an iron plate, or some other flat article, must be provided to stop the draught when required, by being placed upon the top of said flue. It is manifest that in a structure of this kind, a fire may be made, and that the smoke will pass out at the chimney; but as soon as the wood is charred, and the fire burns clear, it is intended to admit the heated air into the barn, and to stop the draught through the flue, or chimney. For the purpose of admitting the heated air, the pen, or box, before described, is provided with an iron, or other door, or stopper, opening from it into the barn. This door may be twenty inches square; it may be fixed by hinges, or otherwise, so that it may be opened as soon as the smoke has ceased to escape from the chimney, and at this time the top of the chimney may have its cover placed so as entirely, or partially, to stop the draught through it. A second flue, or stove, constructed exactly like the one just described, with all its appurtenances, is to be erected on the opposite side of the barn. The pens, or boxes, forming the termination of each of these flues, or stoves, will thus leave a passage of about two feet between them, on the centre of the floor. These flues, or stoves, may be used either separately or conjointly; it will be found best, however, always to make a fire in each, as VOL. VII. No. 6.-JUNE, 1831. 49 ८ HOWARD'S Bucket Water Wheel. there will then be no interval in which the heated air from the fire may not be admitted directly into the barn. The manner in which the heat may be regularly distributed, and applied to the curing of tobacco, is fully described in the specification of a patent for a new mode of curing tobacco, which was granted unto me on the 1st day of October, 1830. To the system, or mode of procedure therein described, these flues and stoves are particularly adapted, but they may also be used when tobacco is cured in the ordinary way.
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- Burke's 1847 Patent Office list gives the same patent.