Drawings and documents
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 10 (1832), p. 84 · View the page
4. For an improvement in the method of Setting the teeth of Mill Saws; Norman Urquhart, Madison county, Alabama, February 7.
Remarks. The two lower teeth of a mill saw are to be set "one-quarter of an inch wide, and three-eighths of an inch from the edge of the tooth in towards the blade." When this has been done, a tooth is to be marked, the distance of which from the bottom of the saw is equal to four times the length of the crank; neither this tooth nor any of those above it are to be set, but the teeth between this and the lower teeth are to be set so that their points will just touch a straight edge laid on each side of the saw, from the marked to the wide set tooth at bottom. The set of the teeth will thus decrease regularly in width from the bottom to the marked or unset tooth. The patentee says that when thus set a saw will cut with increased speed and power, whilst it will run perfectly free from all side friction.
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- Burke's 1847 Patent Office list gives the same patent.