Drawings and documents
National Archives restored drawings: drawing
Iram Brewster's Patent Drawing for a Churn
National Archives, Restored Patent Drawings (Record Group 241) · Full-size scan at the National Archives · Catalog record
Show the text on the drawing Hide (98 words)
Words on the drawing as machine-read by the National Archives; not checked. Useful mainly for searching.
31. DAIRY. / Rotary Churns. / Horizontal Single Dasher. / Rotany Charns / Rotary / agr. products / Iram Bruvster / 10 / CLASSIFICATION / 8566-X 8566 / thurn. / Voe 22. 22. ps. 5% / DIVISION. / Patented Jan 7. 1835. / 83 / Fig. / h. / d. / Preferences. / a. the frame. b. horizontal crank shaft, with / pulley X Crank. b.b. upright standards. su Fig.2. / C the lown crank shaft with wingsd.d d.d. / Patent office June 28ᵗʰ 1842 / ee pitmans. off mortices in the Handards. / h . h. lid. / Madi under the direction of the Commificater / of Patents in conformity with actofstharen 1837. / Bennys Summith / of Patents
USPTO scan
The patent as scanned by the USPTO
U.S. Patent and Trademark Office · Google Patents
Show the transcription Hide (497 words)
Machine transcription (LightOnOCR) of the pages as scanned by the USPTO, most of them the handwritten copies made when the records were restored after the 1836 fire. Not checked; it can misread handwriting, so compare it with the scan.
Page 1.
8566X
I. Brewster, No Printed Specification.
Churn.
Patented Jan. 7, 1835.
Fig. 2.
Fig. 1.

Page 2.
Jan 7, 1835
3566X Shum Brewster Schenectady N.Y.
Letters Patent
The schedule referred to in these letters Patent and making part of the same
Containing a description in the words of the said Shum Brewster himself,
of his improvement in the Churn for making Butter from milk or Cream.
To all persons to whom these presents shall come, Be it known that
I Shum Brewster of the County of Schenectady and State of New York
have invented a new and useful improvement in the Churn, a full
and accurate description of which machine is as follows:—
2. An elongated frame of a width to correspond with the inside of
the Churn, and reaching to the bottom, extending also down the Churn
from eight to twelve inches more or less according to the size of the Churn.
At each end & quite distant from the bottom to the top of the frame there
extends a horizontal shaft from one upright standard to the other, one end
of this shaft passes through one of the standards and carries a crank
or pulley for turning the machine. On this shaft there is formed two
cranks near the inner sides of the upright standards. These have from
three to six inches sweep, more or less and stand at right angles with
each other. Another shaft similar to the one mentioned one (except
that neither end passes through the standards) is affixed and turns in
the standards from eight to ten inches from the bottom parallel with
the upper shaft.
These shafts & cranks are connected together by two
fibrous extensions from the upper to the lower cranks and are
attached thereto by turning the upper shaft with a crank or pulley,
the lower shaft revolves accordingly.
These shafts are made of iron or other suitable
material, & the lower shaft is affixed a set of rings or washers, made
of iron or other suitable material and of a size corresponding to the
size of the Churn. On the outside of the upright standards two notches
or pieces are cut out—one from each standard and forming a kind of
double standard, these fit closely to the inside of the Churn and by
Page 3.
sliding into grooves or staples gives the apparatus firmly to the drum.
The hairpin or irona (Churic) may be had some inches with strong
spatines cut transversely to allow the spitman to jump freely.
This machine may be turned by hand, or water or any power
In witness whereof I have hereunto set my hand this thirtieth
day of November one thousand eight hundred and thirty four.
Witness
A.S. Smith
Robert H. Moore
Irene Brunster
455 287
Published accounts: journal notice
Notice in the monthly list of patents
Journal of the Franklin Institute, new ser., vol. 15 (1835), p. 222 · View the page
3. Churn.-Iram Brewster, Schoharie county, New York,
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 16 (1835), p. 82 · View the page
3. Fora Churn; Iram Brewster, Schoharie county, New York, January 7.
Remarks. There appears to be some novelty about this churn, but that, we apprehend, is its only merit. The description and drawing are both imperfect, and every thing like a claim has been omitted. According to our understanding of the thing, there is to be a vertical tub, as in the common churn, and within this, at a proper height from the bottom, a shaft, having a crank on each end of it, crosses the churn, and carries revolving dashers. Above the top of the churn there is a similar shaft, with two cranks, which shaft is to be turned by a winch. Pitmen connect the upper and lower cranks, so that, when the upper shaft is turned, the lower may likewise revolve, their gudgeons working in the side pieces of a vertical frame, which extends down to the bottom of the churn.
DATAMP: illustration
Illustrations from DATAMP
DATAMP (Directory of American Tool and Machinery Patents), via the Internet Archive · Archived DATAMP page
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP, USPTO records
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, USPTO records, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- Burke's 1847 Patent Office list gives the same patent.