Drawings and documents
USPTO scan
The patent as scanned by the USPTO
U.S. Patent and Trademark Office · Google Patents
Show the transcription Hide (641 words)
Machine transcription (LightOnOCR) of the pages as scanned by the USPTO, most of them the handwritten copies made when the records were restored after the 1836 fire. Not checked; it can misread handwriting, so compare it with the scan.
Page 2.
United States Patent
Patent No.: X8819
Patrick M. Gilroy & Abner S. Tompkins.
Letters Patent
The Schedule referred to in these Letters Patent and making part of the same, containing a description in the words of the said Patrick M. Gilroy & Abner S. Tompkins, themselves, of their improvement in the Damask Loom.
To all to whom these presents shall come: Be it known, that we, Abner S. Tompkins, of North Providence, in the County of Providence, and Patrick M. Gilroy, of Warwick, in the County of Kent, and both in the State of Rhode Island, have invented a new and useful improvement in the damask loom, consisting of the application of water or other power to drive the loom, and the following is a description of the machinery by which this result is produced viz:— Two suitable shafts are placed across near the centre of the loom, running on bearings, one on the lower and the other on the upper girths. The power is applied by a belt to a pulley on one end of the upper shaft—a small gear wheel on the other end of this shaft gears into a large one on the bottom shaft. On the lower shaft is a set of cumbly the number corresponding with the number of treadles to be used which varies with the kind of work to be performed. The large cumb in the above set by means of a large treadle turns the cylinder (as it is commonly called though it is a square block) by which the figure is produced & governs the same. Instead of this treadle, a perpendicular lever with a pulley on it for the large cumb to bear on, may be used. The large cumb & the large treadle or lever and pulley are connected with the back harness by means of lever rods & weights to govern them. The other cumbly above referred to spring the treadles connected with the front harness, & give the shed for the shuttle to pass through. The shuttle is thrown by a triangle attached to the sword of the lay. Near the end of the lower shaft are two cumbly connected with the shuttle motion by a lever rod, the effect of which, is to suspend the motion of the shuttle at pleasure, for any purpose, and leave the loom in operation. The back end of the triangle strikes against the face of a dog, which
Page 3.
United States Patent
Patent No.: X8819
is connected with the upper end of the rod aforesaid, and is attached to the plate of the loom on the back side of the sword of the lay. The lay is suspended on bearings placed on the top plates of the loom, but may be hung at the bottom, as in the common Power Loom. The motion of the lay is produced by screws connected with it & a crank on each end of the top shaft. There is a set screw in the above triangle to govern the traverse of the shuttle lever, or the set screw may be put into the sword of the lay. The dog face has a blank in it and is confined to the dog by a set screw. We claim as our improvement the above combination of machinery, constituting the application of power to drive the damask loom, and particularly the large cam & large treadle, or the lever & pulley as a substitute and the two small camby at each end of the cotton shaft.
Witnesses:
Nathan Whiting
John T. Green
Homer S. Tompkins
Patrick M. Gilroy
Published accounts: journal notice
Notice in the monthly list of patents
Journal of the Franklin Institute, new ser., vol. 16 (1835), p. 71 · View the page
269. Damask loom. Tompkins and Gilroy, North Providence, R. I.
Published accounts: journal notice
Notice in the monthly list of patents, with remarks
Journal of the Franklin Institute, new ser., vol. 16 (1835), p. 391 · View the page
19. For an improvement in the Damask Loom; Patrick M. Gilroy, Warwick, and Abner S. Tompkins, North Providence, Rhode Island, May 9.
Remarks. This improvement in the damask loom consists in the application of water, or other, power to drive it. The general arrangements by which this is effected resemble those of the ordinary loom, but, of course, so varied as to adapt them to the purpose in hand; the treadles are worked by cams, just in the same way, and one also is used for operating upon the cylinder, or apparatus, by which the pattern is given; or a perpendicular lever with a pulley on it, for the large cam to bear on, may be used. In either case, the large cam is connected with the back harness by means of levers and rods, and weights to govern them. The claim is to "the combination of machinery constituting the application of power to drive the damask loom, and particularly the large cam, and large treadle; or the lever and pulley as a substitute, and the two small cams on each end of the bottom shaft."
About this record
- Patentee
- DATAMP
- Date
- the Name and Date index of patents, DATAMP, USPTO records
- Invention
- DATAMP
- Listed in
- the Name and Date index of patents, DATAMP, USPTO records, Jim Shaw's X-patent list, the Journal of the Franklin Institute, Burke's List of Patents (1847)
- The Franklin Institute's journal spells the name differently.
- Burke's 1847 Patent Office list gives the same patent.